Gas Component Connection Checks - RealFlame T9650 NG El Manual Del Propietario

GAS COMPONENT CONNECTION CHECKS

If the burner will not light or stay lit, please perform the following checks.
1. Make sure the electrode wire is correctly connected.
Both electrode wires must be fully inserted into the igniter box.
2. Make sure that the pilot housing is unobstructed.
Clear any debris on top of the pilot housing and make sure there is no debris
between the igniter pin, thermocouple and the burner tube.
CORRECT
15
Pilot Housing
Burner
Tube
Do not block
opening
INCORRECT