Setting The Clock - memorex MiHT5005 Guía Del Usario

SETTING THE CLOCK

1
Press and hold the CLOCK button until "24 HOUR" or "12
HOUR" appears in the display.
3
Select the current hour using the Navigation π/Preset + 1
or †/Preset - 2 button, making sure to set the correct AM
or PM setting if in 12 hour mode. Then press the CLOCK
button 3; the minutes will blink.
NOTES:
• You must press a button within five seconds or the clock will exit the clock setting mode.
• The time will be reset when the power cord is disconnected or if a power failure occurs.
• When the unit is on, press the CLOCK button to show the actual clock. Press the CLOCK button again to resume
normal operation.
SETUP MENU (CONTINUED)
3
1
2
2
Select 12 HOUR or 24 HOUR using the Navigation
π/Preset + 1 or †/Preset - 2 button, then press the
CLOCK button 3; the hours will blink.
4
Select the current minutes using the Navigation π/Preset
+ 1 or †/Preset - 2 button, then press the CLOCK button
3; the clock will then be set.
24
3
1
2
3
1
2