Imesa IM9 Instruciones De Utilizo página 12

E021001C
In this second case the machine is in stand by
until pressing the key "START". In this way the
program starts again.
In case you wish to stop running programme,
please press "PR1" for 5 seconds; display will
show "WAIT". Machine will stand by for one
minute; it will then be possible to open the door.
9. THE "COOL DOWN"
Before choosing a programme or while the
programme is working it is possible to select the
cool down function by pushing the appropriate
button. When the function is selected the
corresponding light is on. To stop the function
press the same button. In this case the light is off.
When the cool down function
water cools down before draining. The machine
unloads the hot water and loads the cool one until
40° C. This procedure avoids thermal shocks of
the linen.
10. "NO SPIN"
Before choosing a program or while the program
is working, it is possible to select the "no spin"
function. This option can be selected by pushing
the appropriate key. When the function is selected
the corresponding light is on. To stop this function,
press the same button and the corresponding light
will be off.
is selected, the
12
By selecting the "NO SPIN" function the running
spin stops; also the following spins will be
interrupted. With the interruption of the spin the
display shows "NO SPIN" till the inner drum stops.
The program will start automatically from the next
cycle.
11. THE SOAKING
During prewashing, washing and rinsing it is
possible to select a soaking pushing the key
"START" for three seconds. The function of
soaking can be interrupted
"START" for three more seconds.
12. ADDITIONAL WATER LOAD
During the prewashing, washing and rinsing, it is
possible to increase the water level in the inner
drum. By pushing the "DOOR OPENING" the
valve of cold water opens. The loading of
additional water goes
OPENING" is pressed. During this operation the
display shows "H O".
2
13. HOW TO OPEN THE DOOR
The door can be opened only when the light near
the key "DOOR OPENING" is on. The door can be
always opened before a program starts or at the
end of a program (the display shows "END").
If in the machine the door handle is not available,
the door glass opens automatically by pushing the
key "DOOR OPENING".
If the door handle is available, use it according to
the model (by rotation of the door handle or
07/10/02
pushing again
on till the "DOOR