Little Seeds 6849196BRU Instruciones De Montaje página 34

Step 26
IMPOBTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVERl
FOLLOW THESE INSTRUCTIONS TO INSTALL THE ANTI-TIPPING SAFETY BRACKET
PROVIDED WITH THIS PRODUCTl
WABNING
SPPPouP oP fPtPl cPuPhPng PnjuPPPP
can occur from furniture tipover.
To prevent tipover:
* Install tpover restraint provided
* plale heaviest items in the lowest
drawers
* Unless specifcally designed to
allomodate, do not set TVs or other
heavy objelts on the top of this
prodult
* Never allow lhildren to llimb or
hang on drawers, door, or shelves
* Never open more than one drawer
at a tme
Use of tipover restarints may only
PPducP, but not PlPmPnPtP thP PPPk
of tipover
OPTION 1: Attachment into a wall stud (preferred method)
Using a stud fnder, locate a stud in the wall. Place your unit against the wall, with the safety bracket
aligned in this locaton.
To male driving the slrew easier, you lan drill a 1/8" diameter pilot hole (3mm) through the safety
brallet into the studl
Drive the slrew through the safety brallet into the wall studl Tighten the slrew that was not fully
tghened in step 5.
OPTION 2: Attachment into drywall
Lolate your unit where desired against a wall and marl the wall through the safety brallet, then
move your unit asidel
Drill a 3/16" diameter hole (5mm) into the wallboard. Tap the wall anchor into the hole untl it is flush.
Move your unit into locaton and fasten the wall bracket to the wall anchor with the screw.
Tighten the screw that was not fully tghtened in step 5.
lil leseedslidsllom
For Masonry, Concrete, or other
PPll mPtPPPPlP:
Consult your lolal hardware store
for appropriate anlhors to selurely
alach the safety bracket.
34
TM
hole
stud
wallboard