Canopy Assembly - Craftmade WXL52AG Guia De Instalacion

6. Wiring. (cont.)
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended
for use. Write down number sequence for use in
Section 10.
Note: Since this fan comes with candelabra base
bulbs, the dimmer switch (labeled D and X) has
been pre-set to the "ON" position (D). If you do not
wish to have dimming capability, please move the
switch to the "OFF" position (X).
Install one 12-volt battery (included) in wall
control. Attach wall control to outlet box and
secure with screws from original wall switch.
Attach front plate to wall control using 2 screws
provided with the wall control.
Important: Wall control will not function unless
battery is installed.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw. Lift
canopy to hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely. Slide canopy cover up to
canopy, aligning rounded part of slotted holes in
canopy cover with screwheads in bottom of canopy.
Turn canopy cover to the right (clockwise) until it
stops.
outlet box
green/ green/ green/
bare bare bare
ground ground ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
screw
page 8
wall
control
-
1 1
- 2 2
green
black (OUT to fan)
black
(TO POWER supply)
12V battery
hanging bracket
canopy
screw
canopy cover
plate
code
switches
dimmer
switch