Canopy Assembly; Blade Assembly - Craftmade LOU52 Guia De Instalacion

7. Canopy Assembly.

Remove 2 screws on underside of hanging
bracket.
Lift canopy to hanging bracket. Align holes in
canopy with holes in hanging bracket. While
holding canopy in place, slide anti-sway
adapter up to canopy. Align holes in anti-sway
adapter with holes in bottom of canopy and
then re-insert the screws that were previously
removed. Tighten both screws securely.
Slide canopy cover up to anti-sway adapter,
aligning rounded part of slotted holes in
canopy cover with screw heads in bottom of
anti-sway adapter. Turn canopy cover to the
right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate12 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes with motor screw holes
and attach blade arm with lock washers and
blade arm screws. Before securing screws
permanently, repeat procedure with
remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
lock washers
page 7
antenna
hanging bracket
canopy
anti-sway adapter
canopy cover
motor housing
blade attachment
screws and washers
blade
blade arm
blade arm
screws