Canopy Assembly; Blade Assembly - Craftmade ELLINGTON E-BEL52BNK3CRW Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely. Slide canopy
cover up to canopy, aligning rounded part of
slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 9 blade attachment screws and
washers and 9 decoratvie nuts in one of the
hardware packs. Place blade arm on TOPSIDE
of blade, aligning holes in blade arm with
holes in blade as shown. Insert 3 decoratvie
nuts into holes from UNDERSIDE of blade (i.e.,
the side that will face the floor), making sure to
completely insert each decorative nut so that
the blade arm can be attached correctly.
Insert 3 blade attachment screws (along with
washers) from TOPSIDE of blade with fingers
first and then tighten screws securely with
Phillips screwdriver. Repeat procedure for
remaining blades.
Remove blade arm screws and lock washers
from fan motor and set aside. [WARNING: Do
NOT remove the 4 screws located on the
outer rim of the underside of the motor
housing--doing so or any attempt at doing so
will void the warranty.] Align blade arm holes
with motor screw holes and attach blade arm
with lock washers and blade arm screws.
Before securing screws permanently, repeat
this procedure with remaining blade arms.
Secure all screws.
Note: Tighten blade arm screws twice a year.
receiver
canopy
screw
lock washer and
blade arm screw
page 7
hanging
bracket
antenna
screw
canopy cover
motor
housing
blade attachment
screws and washers
blade arm
blade
decorative
nuts