Phil & Teds peanut Manual Del Usuario página 5

also raised bumps between each set of
brackets – these will help keep the legs in
place once they are hooked into the
brackets.
d To hook the legs into the plastic base
brackets; hold the plastic base with one
hand and the head end leg with the other.
Lift the base upwards and hook the leg
under the two small plastic brackets on
the base. Ensure they are fully engaged in
each bracket before moving on. Repeat
for the legs at the foot end.
The legs are made from spring steel, giving
them tension, so you'll have to use a bit of
muscle power to hook them under the
second set of brackets!
e Next, locate the four exposed sections of
the cord loop that runs around the bottom
of the fabric side wall. Pull the cord sections
from opposite sides into the middle of the
plastic base and hook them together.
Repeat for the second set of cord loops,
making sure they are securely fastened to
each other before moving on.
f Turn the peanut over and place the
mattress inside, so the sponge-like fabric
is facing upwards.
g The peanut's cover zips on and off as
required. When you're ready to carry the
peanut the handles will slide up the legs to
provide more handle length.
final check points!
Before placing your precious bundle into the
peanut, ensure:
• The legs are fully engaged under the
brackets on the plastic base (see step 'd')
• The cord loops are hooked together
securely.
attaching the nutshell
h Pick up your nutshell and open it out with
the elastic edge at the bottom, as shown.
i Locate the two holes on the top of the
peanut frame (on both sides of your peanut)
and slot the ends of the nutshell rods fully
into the holes, making sure the hood is
facing the right way (so it covers the head
end of your peanut!).
j Ease the elastic bottom of the hood around
the aluminium frame.
harness fixing points
If you want to secure your little one in the
peanut, there are two fixing points located
either side of the base, under the mattress
(see no. 8 in the parts diagram). This will
allow you to fasten a harness to the peanut.
attaching the peanut
to the vibe buggy
NOTE: Do not use the peanut fitted to the buggy
in combination with a child in the main buggy
seat and/or double kit.
3