Phil & Teds peanut Manual Del Usuario página 6

Make sure the vibe buggy brake is engaged,
the seat is in the lie-flat position and the pull bar
is removed.
k Stand side-on to your vibe buggy and extend
the peanut handles to their full length.
Hold the peanut by its handles with one
hand and position it over the frame of
the vibe. NOTE: The head end of the peanut
should point towards the vibe front wheel.
With your free hand, guide the peanut latch
hooks, located on either side of the peanut
frame, over the upper pull bar slots on the
vibe frame.
Press down on the latch hook closest to
you, listening for the sound of the hooks
locking in place. Look to make sure the
latch housing is sitting flush on the vibe
frame and the peanut latch lever has
returned to the downward position.
l Still holding the peanut handles with one
hand: reach over to the second latch,
furthest away from you, and press down
on the peanut latch hooks until you hear
them lock into place.
Check both latches are fully engaged by
gently tugging on the handles and making
sure the peanut doesn't come free from
the frame.
m Slide the handles down the legs to sit
neatly out of the way and you're good to
go!
removing the peanut from the
vibe buggy
Make sure the vibe buggy brake is engaged.
n Extend the peanut handles to their full
length. Stand side-on to the peanut and hold
it by its handles with one hand.
o Reach over the peanut to the side furthest
away from you and release the latch hooks
from the vibe frame by rotating the peanut
latch lever upwards and lifting the latch
hooks backwards and upwards. Take the
weight of the peanut with the handles in
one hand, to prevent the far latch from
re-engaging.
p With your free hand: release the second
latch, as before, and lift the peanut away
from the vibe frame.
attaching the peanut to the
classic/sport/dash or
hammerhead buggy
NOTE: Do not use the peanut fitted to the buggy
in combination with a child in the main buggy
seat and/or double kit.
Make sure the buggy brake is engaged and the
seat is in the lie-flat position. Do not remove the
fabric seat from your buggy
q Remove the pull bar from the buggy and
replace with the locking arms (left and right
hand). Make sure they are fully secured
4