Filtrete 3US-AS01 Instrucciones De Instalación Y Funcionamiento página 4

MOUNTING THE FILTER HEAD
ASSEMBLY BRACKET:
You will need: Phillips screwdriver, drill, pencil, fi lter
head assembly bracket (B), #2 mounting screws (H)
1. Choose a location to mount fi lter head assembly
bracket (B). Keep in mind: Bracket should be in
a location that offers easy access for changing
fi lters. Leave 2 ½" of clearance below the installed
fi lter cartridge. (See Fig. 3)
2. Using the bracket (B) as a guide, mark the
location of the two screw holes on the wall with
a pencil. (Fig. 4)
3. Fasten the bracket to the wall using a Phillips
screwdriver and the two mounting screws
included (H). (If preferred, use a drill with a 3/16"
size drill bit to make pilot holes for the screws.)
(Fig. 5)
4. Check to assure mounting bracket is
fi rmly installed.
ATTACH WATER SUPPLY
LINE ADAPTER:
You will need: Adjustable wrench (Note: Two
wrenches may be needed to adequately tighten
fi ttings when connecting the adapter to the
supply line), male water supply line adapter (D)
1. Turn off the cold water supply at the shutoff
valve under the sink. (Fig. 6)
2. Disconnect the cold water faucet hose from
the shutoff valve below using a wrench.
Leave the hose attached to the faucet
above. (Fig. 7)
3. Install the male water supply line adapter (D)
placing the faucet side onto the end of the
faucet hose. Note: Fitting has a faucet side
and a push-in side. (Fig. 8)
Note: If the water supply line adapter (D)
does NOT fi t properly onto the end of your
faucet hose, visit your local hardware store
to purchase the correct size.
Filtrete a 3M Brand
2 1 /
(Fig. 3)
4
(Fig. 4)
C09093B-A5
3US-PS01
"
2
C09093B-A5
Filtrete a 3M Brand
3US-PS01
(Fig. 5)
C09093B-A5
Filtrete a 3M Brand
3US-PS01
(Fig. 6)
(Fig. 7)
(Fig. 8)