Using Allstar And Sizzix Bigz Dies - Ellison Prestige PRO Manual De Instrucciones

Figure J
and Sizzix ® Bigz
™
Using AllStar
1. Raise the handle all the way up.
2. Place the Prestige Adapter Pad on the Prestige Cutting or Crease Pad.
3. Place material to be cut against the rubber side of the die and place rubber
side down on the Adapter Pad (Figures J & K).
4. Slide the Cutting Pad to center the material and die under the Pressure
Plate (see Figure A, page 5). Vary die placement from side to side to
prolong the life of the Cutting Pad (See Figure B, page 5).
5. Lower the handle one time to cut through the material.
6. Keep a firm grip when raising or lowering the handle.
7. Slide the Cutting Pad out from under the Pressure Plate and remove the die
and perfectly cut shapes, letters and numbers.
AllStar Die
Paper
Adapter Pad
™
Dies
8
Bigz Die
Figure K