Thermador TCMTK30RS Manual Del Usaurio página 7

11. Use a 1'' T-20 Torx screw with spacer (shipped with
coffee maker) to secure the top right corner of the
coffee maker.
12. If the door does not shut smoothly, check to see if the
Door Latch is hitting on the top or bottom or the
receiver.
13. If the latch is hitting on the bottom, pull the coffee
maker out and install the 1mm Shim, included with the
coffee maker, at the bottom left side of the coffee
maker.
If the receiver is hitting on the top, install the 1mm
Shim on the top left of the coffee maker.
14. Reinstall the coffee maker. If the receiver hits again
increase the shim size until the Door Latch no longer
hits.
15. Press the Built-in Coffee Maker Trim Kit into the left
and right Side Cabinet Brackets.
Page. 6