Chacon 34953 Guia Del Usuario página 3

Installing Your Smoke Detectors
Read"Locations to Install Your Smoke Detectors" and "Locations
then decide where to install the detector.
Please follow these steps to install your smoke detector:
1. At the place where you are going to install the detector, draw a
horizontal line 15 cm long.
2. Remove the mounting bracket from your unit by rotating it
counterclockwise.
3. Place the bracket so that the two longest hole slots are aligned on
the line. In each of keyhole slots, draw a mark to locate a mounting
plug and screw.
4. Remove the bracket.
5. Using a 5mm drill bit, drills two holes at the marks and
insert plastic wall plugs. Put the detector away from getting plaster
dust on it when you drill holes for mounting.
6. Using the two screws and plastic wall plugs (all supplied), attach the
bracket to the wall.
7. Line up the slot of the bracket and the detector. Push the clockwise
securely attached to the mounting bracket.
Connect with Alarm Control Panel
34953 can not only work as a single station, but also can work
with alarm control panel to form an alarm system when wireless
module is added to the smoke detector.
1) Make sure the control panel is in learning state.
2) Press the testing button on the smoke detector for 3 seconds,
two beeps are heard. Simultaneously, one beep is heard from the
control panel. The detector has been connected successfully with
the control panel.
Testing:
Press the testing button on the smoke detector for 3 seconds, the
control panel will alarm immediately.
8. The steps to open the battery cover and to install the battery are
listed as follows:
(1) To power smoke detector requires a battery.
(2) Match terminals on the end(s) of the battery with opposite
terminal connections on the detector. Be sure to insert the
zinc-manganese dry battery in the position shown on the detector.
until it snaps and cannot be shaken loose.
Red LED Indicator
The red LED, as the ALARM indicator, is featured with the detector.
It can be seen through the test button on the cover of the detector.
under normal operation. When smoke detector senses smoke and
frequently, once 0.67 seconds.
Testing Your Smoke Detector
to 5 seconds to sound the alarm horn. These are only ways to be
sure that detector is working correctly. If the detector fails to test
properly, have it repaired or replaced immediately.
in test switch accurately tests all detector functions, as required by
Underwriters' Laboratories. They are the only correct ways to test
the unit.
CAUTION: This smoke detector comes with cover latches that will prevent
the smoke detector cover from closing if battery is not installed. This tells you
that the smoke detector will not work until a new battery is properly installed.
The battery is purposely positioned WRONGLY in the factory to keep it fresh
until installation. It must be re-positioned correctly to provide DC power.
NOTE :
alarm horn may sound for one second. This is normal and indicates that the
battery is positioned properly. Close cover, then press the test button, holding
it down for about 5 seconds until the horn sounds. The horn should sound a
loud, pulsating alarm. This means the unit is working properly.
WARNING: When you are not testing the unit and the alarm horn sounds
a loud continuous sound, this means the detector has sensed smoke or
combustion particles in the air. Be sure that the alarm horn is a warning of a
possible serious situation, which requires your immediate attention.
The alarm could be caused by a nuisance situation. Cooking smoke
alarm to sound. If this happens, open a window or fan the air to
remove the smoke or dust. The alarm will turn off as soon as the air
is completely clear.
NOTE: Do not disconnect the battery from the detector. This will remove your
a minute, this means the detector's battery is weak. Replace new
battery immediately.
this signal means that the detector is faulting, it is must repaired or
replaced immediately.