Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Powering up the
VIP™ Signal
Distributor
Video
Input/Output
Front Panel View
Signal
Connection
Back Panel View
Back Panel
Connections
This product supports AC from 100 to 240 VAC, 50 to 60 Hz. Once plugged in,
push the Power Switch on the back panel to ON.
Single Signal Splitting
Video Source
(input)
etherCON® (1)
All connections are located on the back panel. See the diagram below.
To run a Backup connection to the VIP™ Driver, the return signal cable can be
connected to the following:
·
One of the eight (8) outputs (marked Number 1 below)
·
Any output of a panel connected through the VIP™ Signal Distributor
·
The Link Up (marked Number 3 below)
1. Signal
2. Signal
Output
Not shown here are the rubber feet that can be attached to the
VIP™ Signal Distributor. These feet are included with the VIP™ Signal Distributor
in separate packaging.
Disconnect power before connecting other equipment to the VIP™ Signal
Distributor.
Number
Signal Output - Connect to signal input of Video Wall System
1
panel
Signal Input - Connect with VIP™ Driver output
2
Link Up/Signal Input - Connect with another VIP™ Signal
3
Distributor
Power/Signal LED Indicators – Red LED shows the power
4
status (On/Off). Green LED will flash when the VIP™ Signal
Distributor and VIP™ Driver are correctly connected.
5
Power Switch - Turns power on/off
Power In - IEC input 100 to 240 VAC, 50/60 Hz
6
VIP™ Signal Distributor QRG
Video Output
etherCON® (8)
3. Link Up/
4. Power/Signal
Signal
LED Indicators
Input
Input
Description
5
Dual Signal Splitting
Video Source
Video Output
(input)
etherCON®(2)
etherCON® (4)
5. Power
Switch
6. Power In
Publicidad
Tabla de contenido
