Homak RD00820290 Manual De Instruccion página 2

WARNING:
1. Read all safety instructions and safety tips before using this product,
failure to do so may result in personal injury.
2. Ground all tools. If the tool is equipped with a three pin plug, it should be
plugged into a three pin electrical socket. Never remove the ground pin.
3. Do not abuse the cord. Never use the cord to carry tools or pull the plug
from an outlet. Keep cord away from heat, sharp edges, or moving parts.
Replace damaged cords immediately. Damaged cords increased the risk
of electronic shock.
4. Do not operate this tool if you are under the influence of alcohol or drugs.
Read warning labels on prescriptions to determine if your judgment or
reflexes are impaired while taking drugs. If there is any doubt, do not
attempt to operate.
5. Use safety equipment. Eye Protection should be worn at all times when
operating this tool. Use ANSI approved safety glasses. Everyday
eyeglasses only have impact resistant lenses. They are NOT safety
glasses. Dust mask, non-skid safety shoes, hard hat, or hearing protection
should be used in appropriate conditions.
6. Wear proper apparel. Loose clothing, gloves, neckties, rings, bracelets,
or other jewelry may present a potential hazard when operating this tool.
Please keep all apparel clear of tool.
7. Don't overreach. Keep proper footing and balance at all times when
operating this product.
8. Always disconnect the tool from the power source before making any
adjustments, storing, servicing, or changing accessories. Such
preventative safety measures reduce the risk of starting the tool
accidentally.
9. Do not use the tool if the switch does not turn it on and off. Any tool that
cannot be controlled with the switch is dangerous and must be repaired.
10. Keep away from children, do not let children operate this machinery.
11. Do not use this product other than what is specified in the instruction
manual.
12. Do not use near open flame or spark. Do not use in the presence of
flammable gas or liquids.
13. Drain compressor and unplug unit when not in use.
14. Use common sense when operating machinery, Homak is not
responsible for injury due to improper use.
15. For indoor use only.
16. Must use water based solvent only.
- 2 -