Homak RD00820290 Manual De Instruccion página 4

Assembly
Bottom Shelf
1. Locate the two Handles (04) and
the Bottom Shelf (13)
2. Align the holes in the bottom of
the Handles with the 4 holes in the
corners of the Bottom Shelf.
3. Place Flat Washers (03) onto the
Bolt (02) and insert Bolt through
Handle and Bottom Shelf.
4. Place Flat Washer (03) and Lock
Nut (07) onto end of Bolt and hand
tighten
5. Repeat steps 3-4 for remaining
holes in Bottom Shelf
NOTE: DO NOT FULLY TIGHTEN
NUTS AT THIS TIME
Middle (Parts Drying) Shelf
1. Locate the Middle Shelf (12) and
the Drain Tank (25)
2. Insert the Drain Tank into the slots
located in the bottom of Middle Shelf
3. Align the holes in the 4 corners of
the Middle Shelf with the holes of the
Handles (04).
4. Place Flat Washers (03) onto the
Bolt (02) and insert Bolt through
Handle and Middle Shelf.
5. Place Flat Washer and Lock Nut (07)
onto end of Bolt and hand tighten
6. Repeat steps 4-5 for remaining holes
in Middle Shelf.
NOTE: DO NOT FULLY TIGHTEN
NUTS AT THIS TIME
Tank Mounts
1. Locate the Left Tank Mount (06) and
Right Tank Mount (25).
Note: Right Tank Mount has hooks for
electrical cord storage.
2. Align the holes in the Left Tank Mount
with the uppermost holes in either
Handle (04).
3. Place Flat Washers (03) onto Bolt
(02) and insert Bolt through Handle and
Left Tank Mount.
4. Place Flat Washer and Lock Nut (07)
onto end of Bolt and hand tighten.
5. Repeat steps 3-4 for remaining hole
in Left Tank Mount.
6. Align Holes in the Right Tank Mount
with the holes in the remaining Handle.
Hooks on Right Tank Mount should be
facing away from center on unit.
7. Follow steps 3-5 to install Right Tank
Mount.
- 4 -