Homak RD00820290 Manual De Instruccion página 6

ON positon.
4. Clean parts as needed.
5. Turn power switch to the OFF position.
6. Place parts on drying shelf until completely dry.
7. Empty drain tank, as needed, by sliding out of drying shelf brackets.
WARNING: CLEAN OFF ANY ACCIDENTAL SPLASHES OF SOLVENT ON
SKIN IMMEDIATELY, FOLLOWING THE SOLVENT MANUFACTURER'S IN-
STRUCTIONS CAREFULLY. SEEK MEDICAL ATTENTION IF NECESSARY.
When Not In Use:
1. Switch off pump, close the lid and disconnect from electrical supply
2. Disconnect from the electrical supply before carrying out any maintenance or
cleaning on the parts washer.
Maintenance
1. The lid incorporates a fusible link to close the lid in the event of a fire. This link
is non-resetting and must be replaced once it has been triggered.
2. Clean the pump filter regularly by sliding it away from the pump housing and
rinsing in clean solvent.
3. Do not allow the level of liquid in the parts washer to fall below the pump inlet,
as damage to the pump can result.
4. Change solvent as needed. Tank can be drained by removing the drain plug
located on bottom of the tank.
Powder Coat Finish
For heavy build-up of dirt and grime, our powder coat paint finish can be
cleaned with spray wax. Lightly spray the wax on the surface, and gently
wipe with a soft, dry microfiber cloth.
Window cleaner and a soft cloth dampened with water can be used to
clean the finish on a regular basis.
Customer Satisfaction
All mechanical parts are inspected and adjusted for proper use before
shipment; however, there may be some shifting of parts during transit.
Should any item not operate correctly, please call customer service at
1-800-874-6625.
- 6 -