Operating The Device; Switching The Parents' Unit And Baby Unit On And Off; Setting The Channel - Silvercrest BABYTALKER 1030 Manual De Usuario

11.4.4 Charging batteries in the parents' unit
- Connect the power adapter (7.5 V
to a mains socket (230-240 V~ 50 Hz).
- The flashing battery charge indicator in the display
shows that the batteries are being charged:
• The batteries take about 12 hours
to charge.
• The batteries are charged continuously.
Therefore the flashing battery charge
indicator in the display is still visible even
when the batteries are fully charged.
12

Operating the device

12.1 Switching the parents' unit and baby unit on and off

- Press the On/Off button
- To switch on the baby unit, press the On/Off button
- To switch off the parents' unit, press and hold the On/Off button
- To switch off the baby unit, press and hold the On/Off button
• Before setting the channel (see section "12.2 Setting the channel") and/or
activating/deactivating privacy mode (see section "12.3 Activating privacy mode"),
make sure that the VOX sensitivity switch
clockwise (lowest level). Also make sure that you configure the settings on the
baby unit in a quiet environment.
- The reason for this is that the baby unit starts transmitting as soon as the

12.2 Setting the channel

To have communication between the baby unit and the parents' unit they both need to be set on the same
channel.
- Press the channel up
on the parents' unit.
- Press the channel up
channel as on the parents' unit.
Once both units are set to the same channel, the parents' unit can receive the signal from the baby unit.
When on one or both units is displayed, the privacy mode is activated.
See section "12.3 Activating privacy mode"
58
to switch on the parents' unit. The display
9
microphone picks up a sound. You cannot change the settings on the baby unit
while it is transmitting (TX is shown in the LCD display on the baby unit).
or channel down
3
or channel down
15
300 mA)
. The display
18
18
on the baby unit has been turned
24
button on the parents' unit to select the channel
4
button on the baby unit to select the same
16
Babytalker 1030
illuminates.
14
illuminates.
until the display goes out.
9
until the display goes out.