ANSMANN 254PD Manual De Instrucciones página 7

USE
PD capable
CHARGING DEVICES
In order to charge a device, such as a smartphone for example, please
use a suitable USB-PD cable or the original charge cable for your
device. The USB-PD charger has a Type-C and USB-A output. Please
use a suitable Type-C cable for this. Insert the USB / Type-C plug of
the cable into the USB-PD charger and the other end into your device.
The charging process starts automatically.
The USB-PD charger has both USB and Power Delivery (PD) protocols.
In order to be able to use this technology, please check that your
end-device is compatible.
Simultaneous charging of multiple end-devices is possible with
restrictions. This is dependent on the total required charge current
and charge voltage.
The USB-PD charger switches off automatically once the charging is
complete. Please disconnect your device from the USB-PD charger
once the charging process is complete.
The USB-PD charger may heat up a little depending on the output
power required.
USE
NOTE: MAINS VOLTAGE 110-240V
The USB-PD charger is suitable for a mains voltage of 100-240V and
so can be used throughout the world. Please note that a suitable
country-specific adapter may be required for this.
NOTE: POWER DELIVERY
Automatic detection: No manual adjustments or changes re-
ƒ
quired - only the correct components are required (cable and
end-device must be PD-compatible).
USB Type C PD
capable
PD capable Quick charging
High power