JBL ProTemp b10 Manual Del Usuario página 8

Ocultar thumbs Ver también para ProTemp b10:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
this purpose and be aware of the risks of use. The appliance is not a toy. Children should
not clean the appliance or do maintenance or repair work on it unless they are over the
age of 8 and are being supervised.
The heating cables operate with extra-low voltage of 12 V. They may only be used with
a matching JBL transformer. Connect the heating cables to the mains directly will
destroy them and may cause them to catch fire.
Make sure that the voltage indicated on the transformer corresponds to the mains voltage.
Before using the appliance for the first time, make sure it has been installed safely.
Before any work is done on the transformer, the power supply must be disconnected by
pulling the mains plug. The plug should never be pulled out of the socket by the cable.
Always hold the plug when disconnecting.
Never install the transformer above the water level.
The appliance should not be used for any purpose other than its intended purpose.
The use of accessories or parts not recommended by the manufacturer can lead to
hazardous situations and a loss of warranty.
PLEASE NOTE: Prior to carrying out maintenance work, make sure to disconnect all of
the electrical appliances in the aquarium.
If the power cable of the device is damaged, avoid hazards by having it replaced by the
manufacturer, the manufacturer's customer service or a person of similar qualification.
Do not place the transformer near any sources of heat.
Avoid electric shock by never immersing the appliance, mains plug or mains cable in
water or any other liquid.
Do not open the transformer.
Parts and names (Fig. 1)
1.
Power cord
2.
Electronic transformer
3.
Cold cable 12 V (lead)
4.
Marking (transition from the cold cable to the heating cable)
5.
Heating cable, 12 V
6.
Mounting suction cups
7.
Connecting terminals for the power cord (pre-installed)
8.
Connecting terminals for the 12 V cold cable (lead)
9.
Strain relief
10. Cover of the connecting terminals
Optimal set-up (Fig. 2):
11. Heating cable
12. JBL AquaBasis plus substrate: Layer thickness 1.5 – 4 cm
13. Top layer for JBL Manado: Layer thickness 4 – 8 cm
Technical data:
Type
Heating capacity (W)
Length of heating cable
(m)
Length of heating cable
(m)
6
ProTemp b10
ProTemp b20
Data for the 12 V heating cable
10
3.60
2 x 1.80
ProTemp b40
20
40
4.90
7.00
2 x 2.00
2 x 2.20
ProTemp b60
60
9.00
2 x 2.50

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Protemp b20Protemp b40Protemp b60

Tabla de contenido