Maintenance - Smartpond 52285 Manual Del Usuario

Step 4. Return water to the pond
by connecting tubing to the outlet
of the UV Clarifier and to the inlet
of a water feature or return to the
pond. You can reconnect your
pump into a properly grounded
electrical outlet at this time.
Note: The outlet on the UV
Clarifier is marked "OUT".
Step 5. Connect the UV Clarifier
into a properly grounded
electrical outlet.
Step 6. Wait several seconds
then check the indicator light to
verify if the UV bulb is functioning
properly.
NOTE: This UV clarifier includes
a safety feature that will not allow
the light to turn on if the lamp
holder or locking ring are not
securely fastened.

MAINTENANCE

To maximize the performance of the UV clarifier, periodically
disassemble the filter to clean dirt and debris from the exterior of the
glass tube and inside light housing. Check the UV bulb to make sure
that it has nor burned out. Replace the bulb as necessary, or after every
season.
Step 1. Disconnect the UV
Clarifier from the outlet. Allow
a sufficient time to pass
for the light to cool before
disassembling the light.
Step 2. Rotate the locking ring
counterclockwise to remove the
lamp holder.
Step 3. To replace the bulb,
remove the bulb holder.
Carefully remove the old bulb
by pulling firmly on the base.
Carefully install the new bulb
and put the bulb holder back in
place.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO LOWE'S: 1-888-755-4497
5
GFCI
outlet
4
6
2
3
5