Periodic Inspections; Device Life - Kong Body futura Manual De Instrucciones

the device has dried out, being careful to avoid contact
with textile components.
In addition, if necessary:
- disinfect the device, soaking it in warm water containing
1% of sodium hypochlorite (bleach). Rinse with drinking
water and, without spinning, leave it to dry without
leaving it in the direct sunlight. Avoid sterilising textile
devices in an autoclave.
Storage: store the devices in a dry (40-90% relative
humidity), fresh (temperature 5-30°C) and dark place,
chemically neutral (absolutely avoid salty and/or acid
environments), away from sharp edges, corrosive
substances or other possible detrimental conditions.
4 – PERIODIC INSPECTIONS
We would strongly advise having pre and post use
controls carried out by qualified individuals, as indicated
in the instructions for the specific device.
Except in the case of more stringent legal requirements,
devices must be inspected annually and the inspections
must be performed by a competent person that has been
trained and authorised by the manufacturer. The outcome
of these periodic inspections must be recorded on the
device's inspection chart.
5 – DEVICE LIFE
Read point 1C very carefully. The life of metal devices is
theoretically unlimited, while textile and plastic devices
can last 10 years from the date of production as long as:
maintenance and storage are carried out as described
in point 3, the results of pre-use, post-use and periodic
inspections are all positive, and the device is used
correctly, not exceeding 1/4 of the indicated load.
Discard any devices that do not pass the pre-use, post-
use and periodic inspections.
6 – LEGAL OBLIGATIONS
Professional and recreational activities are often regulated
by specific national laws that may impose specific
limits and/or requirements for the use of PPE and the
preparation of safety systems, which included the PPE in
their components. The user is obliged to know and apply
these laws, which may in some cases impose obligations
different from those contained in this information.
7 – GUARANTEE
The manufacturer guarantees that the device complies
with regulations in force at the time of production. The
guarantee covering faults is limited to production defects
and raw materials. It does not include wear and tear,
oxidation, damages caused by improper use and/or
during competition, incorrect maintenance, transport,
conservation, storage, etc. The guarantee becomes void
as soon as the device is modified or tampered with. The
validity corresponds to the legal guarantee of the country
where the device was sold by the manufacturer, with effect
from the date of sale. After this period no claim can be
made against the manufacturer. Any request for repair or
replacement under this warranty must be accompanied
by a proof of purchase. If the defect is accepted, the
manufacturer, at its sole discretion, will repair, replace
or refund the device. Under no circumstances does the
manufacturer's liability extend beyond the invoice price of
the device.