EB TECHNOLOGY TRANSCEIVER-TXMINI Instrucción página 12

TRANSCEIVER v2
First Installation
Receiver
1
Put all DIP-SWITCHES in OFF position (Tx and Rx)
Supply power to the receiver 12/24 Vac/dc,
2
if 12V make a link to JUMPER 12V.
LED-0 and LED-1 flashes fastly and the receiver make a "beep" sound.
Cancel of the memory of the receiver
This operation should be done at the first installation
Cancel the memory of the receiver: keep pressed the P1-PROG
3
for 12 seconds, when the receiver sounds, release the button.
Transmitter
4
Connect to the terminal board the N.C. contact or the 8.2 K resistive edge contact
Select the input with DIP-SWITCH 2 for Input 1 and DIP-SWITCH 3 for Input 2:
5
OFF: Select an input for a N.C. contact
ON: For a 8.2 K resistive edge contact
Give power supply on the TX with two 1,5V batteries LR06 AA:
6
LED-1 of the transmitter fl ashes fast and then slowly.
Reseting the TX
This operation should be done at the first installation.
7
Press and keep pressed both P1 and P2 of the transmitter
After 5 seconds the l.e.d. are lit on to indicate the cancellation of the memory.
8
Release the buttons. The memory will be cleared of all previously memorized
installations.
-12-
Technical manual
TX
RX
1 2 3 4
12 V 24 V
> >
P1 PROG BUZZER P1 PROG
Safety edge 1
7
8
COM coste
9
Safety edge 2
ON
1 2 3 4
DIP 2-3 TX
ON 8K2 - OFF NC
led
TX1
+
P1 - TX P2 - TX
led
TX1