EB TECHNOLOGY TRANSCEIVER-TXMINI Instrucción página 15

TRANSCEIVER v2
Signal quality indicated by the Buzzer
With DIP 4 in the receiver is in ON position, it indicates the signal quality of the buzzer.
It beeps from 1 to 5 and it indicates signal quality
and each 12 seconds in the PASSIVE CONTROL MEMORIZATION,
while 120 seconds each in the ACTIVE CONTROL MEMORIZATION.
The buzzer indicates the quality of the signal through a "beep sound" 1 beep is not
suffi cient, 5 beeps indicates excellent quality of the signal
LED-RX1 Signal quality
The LED-RX1 of the receiver flashes when one Tx is in alarm (you can test this by opening a N.C. contact
of the terminal board of the TX). The l.e.d. flashes from 1 to 5 times and it indicates the signal quality of the
transmission:
1 fl ash: not good signal
Check with DIP-1 OFF in the TX and in the RX
If you push P2 of the receiver for 5 seconds, the receiver will work in CHECK: the buzzer will sound to confirm
the operation. This operation can test the transmission of the TX. The function will be in CHECK for 5 minutes
until P2 on the RX is pressed. During the CHECK operation the receiver will sound constantly to indicate the
correct operation of the TX while it will beeps for 3 times to indicate the incorrect transmission of the TX. When
the receiver is out of the CHECK operation, the receiver will give one long beep if the transmission with the
TX is correct while it will beep 3 times if there is a problem with the tx. During the CHECK operation, the gate
can move.
TX Battery warning
The receiver will be for 3 times if the battery of one TX is not working properly:
• The beep is every 12 sec in the PASSIVE CONTROL MEMORIZATION
• The beep is every 120 sec in the ACTIVE CONTROL MEMORIZATION
• The beep is every time it appears the safety
...
-15-
Technical manual
ON
1 2 3
1 beep
not good signal
...
5 beeps:
very good signal
5 fl ashes: very good signal
4