GE Cafe CT9570SLSS Instrucciones De Instalación página 2

2 A
CUTOUT FOR DOUBLE OVENS (2 THERMAL
OVENS)
NOTE: If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick,
shim both sides equally to establish the cutout width.
H
E
Cutout Depth
23-1/2"
(59.7 cm) Min.
M
Dim. Description
A Cabinet width
B Cutout width
C Cutout height
D Clearance from cutout - side edges*
E Lower door clearance to adjacent corners,
drawers, walls, etc., When door is open
F Clearance from cutout - top*
G Clearance from cutout - bottom*
H Junction box location
J Height to bottom of junction box
K Recommended cutout location from floor
L French (upper) door swing depth - Allow additional
clearances for installation and oven usage
M Countertop or cabinet door protrusion
(measure if exist)
N Gap between edge of countertop
or cabinet door to cabinet opening
* Refers to minimum clearance required for wall oven installation and does not reflect actual product dimensions.
Continue to Section 3.
B
Junction Box
Location (junction
box may be
located in
adjacent cabinet)
F
D
J
G
A
N
C
L L
30" Double Oven with 30" Double Oven without
Pedestal Pedestal
30" (76.2 cm) 30" (76.2 cm)
28 " (72.4 cm) min. 28 " (72.4 cm) min.
1 2 1 2
28 " (72.7 cm) max. 28 " (72.7 cm) max.
5 8 5 8
51 13 16 " (131.6 cm) min. 50 ¼" (127.64cm)
51 15 16 " (131.9 cm) max.
" (1.75 cm) " (1.75 cm)
11 16 11 16
23" (53.3 cm) min. 23" (53.3 cm) min.
1" (2.5 cm) min. 1" (2.5 cm) min.
(1 1 4 " (3.2 cm) (1 1 4 " (3.2 cm)
1 " (3.2 cm) 1 " (3.2 cm)
1 4 1 4
9 " (24.1 cm) max. 9 " (24.1 cm) max.
1 2 1 2
right side only right side only
47" (119.4 cm) 47" (119.4 cm)
12" (30.5 cm) 12" (30.5 cm)
16 " (41.3 cm) min. 16 " (41.3 cm) min.
1 4 1 4
Measure "M" Measure "M"
If M = 0, N = 0, Otherwise If M = 0, N = 0, Otherwise
N = M + 1" (2.54 cm) min. N = M + 1" (2.54 cm) min.
2 B
CUTOUT FOR INSTALLATION OVER A
WARMING DRAWER
NOTE: Install the oven only with specific models listed on the label located on top of the oven.
NOTE: Additional clearances between cutouts may be required. Check to be sure the oven
supports above the Warming Drawer location do not obstruct the required interior depth and height.
When installing a Warming Drawer below a double oven, a separate 120V, 60 HZ, properly
grounded receptacle must be installed. Refer to installation instructions packed with the Warming
Drawer for specific installation requirements.
C
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
K
Per Warming
Drawer
Requirement