Product Dimensions; Important; Custom Overlay Panel - KitchenAid KUBR314KSS Guía De Uso Y Cuidados E Instrucciones De Instalación

Opening and utility location dimensions
Opening width - A
Opening depth - B
Opening height - C
Dimension - D
Dimension - E
Dimension - F
Dimension - G
Dimension - H
Dimension - I
For fl ush installation, the power outlet can be installed in
adjacent cabinetry with a cutout on the power cord side
for routing of the power cord.
The power outlet can also be recessed on the back wall
behind the unit as per recommended receptacle locations in
the above illustration.

Product Dimensions

Overall product
Width (up to hinge cover)
Height (up to hinge cover)
Panel ready models depth
(with 3/4" panel and no handle)
Raw Door Height
Depth (no handle)
NOTE: The power cord is 60" (152.4 cm) long.
23 / "
7
8
(60.72 cm)
34 / "
3
8
(87.32 cm)
4
24" (60.96 cm) min.
24" (60.96 cm) min.
34 1 / " (87.6 cm) min.
2
35" (88.9 cm) max.
1
12 / " (30.64 cm)
16
3
21 / " (55.16 cm)
4
3
1 / " (4.44 cm)
4
3" (7.55 cm)
1
4 / " (11.37 cm)
2
1
9 / " (23.47 cm)
4
7
23 / " (60.72 cm)
8
3
34 / " (87.32 cm)
8
13
23 / " (60.5 cm)
16
5
30 / " (77.75 cm)
8
5
23 / " (60.01 cm)
8
Depth
(no handle)
30 / "
5
8
(77.5 cm)

Custom Overlay Panel

NOTE: For standard stainless steel or glass door models, skip
these instructions and go to "Electrical Requirements" section.
If you plan to install a custom overlay panel, you will need
to create the panel yourself or consult a qualifi ed cabinet
maker or carpenter. Refer dimension drawings for panel
specifi cations.

IMPORTANT:

The thickness of the overlay panel must be 3/4" (19 mm).
Custom solid door overlay panel must not weigh more than
20 lb (9.07 kg).
Custom glass door overlay panel must not weigh more than
10 lb (4.54 kg).
Overlay panels weighing more than recommended may
cause damage to your appliance.
Solid door overlay panel - Preparation:
Create the custom overlay panel using the dimensions shown
in the illustration "Solid door overlay panel and hinge routing
dimensions". Route shaded areas to a 1/2" (12 mm) depth as
shown.
IMPORTANT: The following graphic shows a custom panel for
a door with the hinges installed on the right-hand side.
If your beverage center has the hinges installed on the left-
hand side, rotate the custom frame 180° so the hinge
markings will be on the left.
1/4"
(7 mm)
4 15
1/8"
(3 mm) (125 mm)
1/2"
(12 mm)
Solid door overlay panel and hinge routing dimensions
2"
/ "
16
(53 mm)
23 / "
3
4
(60.3 cm)
30 / "
5
8
(77.75 cm)