Handle (Optional); Electrical Requirements; Installation Instructions; Unpack The Beverage Center - KitchenAid KUBR314KSS Guía De Uso Y Cuidados E Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Glass door overlay panel - Preparation:
Create the custom overlay panel using the dimensions shown
in the illustration " Glass door overlay panel and hinge routing
dimensions". Route shaded areas to a 1/2" (12 mm) depth as
shown.
IMPORTANT: The following graphic shows a custom panel for
a door with the hinges installed on the right-hand side.
If your beverage center has the hinges installed on the left-
hand side, rotate the custom frame 180° so the hinge markings
will be on the left.
1/4"
(7 mm)
4
15
/
16
1/8"
(3 mm)
(125 mm)
1/2"
(12 mm)
Glass door overlay panel and hinge routing dimensions

Handle (optional)

Custom handles are typically attached to the custom overlay
door panel only.
Refer instructions received with KitchenAid handle kits to
install these handles on custom wood panels.
Custom handle needs to be installed on the door panel with
countersunk holes and installed before the custom overlay
door panel has been installed on the beverage center door.
2"
"
(53 mm)
23
3
/
"
4
(60.3 cm)
17
/
"
1
16
30
(43.3 cm)
(77.75 cm)
21
/
"
13
16
(55.4 cm)
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your beverage center into its fi nal location,
it is important to make sure you have the proper electrical
connection.
Recommended grounding method:
A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your beverage center be
provided. Use an outlet that cannot be turned off by a switch.
Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
/
"
5
removing a light bulb, unplug beverage center or disconnect
8
power.

Unpack the Beverage Center

Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
Before using your beverage center, all packaging materials should
be removed and the interior should be cleaned.
Remove tape and glue residue from surfaces before turning on
the beverage center. With your fi ngers, rub a small amount of
liquid dish soap over any adhesive and wipe with warm water
to remove.
Do not use sharp instruments, rubbing alcohol, fl ammable
fl uids, or abrasive cleaners to remove tape or glue.
These can damage the surfaces of your beverage center.
For more information, refer "Beverage Center Safety" section.

Electrical Requirements

Electrical Shock Hazard
INSTALLATION
INSTRUCTIONS
Excessive Weight Hazard
5

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Kubl314kssKubl314kbsKubr314 kbsKubl214ksbKubr214kpaKubr214ksb

Tabla de contenido