Oven Doors; Oven Light Replacement - Cafe CMB903P2NS1 Manual Del Propietário

Care and Cleaning

OVEN DOORS

Lift-Off Oven Door
The door is very heavy. Be careful when removing and
lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame,
to the unlocked position. A tool, such as a small
flat-blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
Hinge lock
Pull hinge locks down to unlock
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
5. Lift door up and out until
both hinge arms are clear
of the slots.

OVEN LIGHT REPLACEMENT

WARNING
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the
oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass
CAUTION
with bare hands or a damp cloth can cause burns.
1. Disconnect power at the main fuse or circuit breaker
panel.
2. Remove oven racks.
3. Remove the screws holding the steel frame.
NOTE: The glass and gasket will be loose and can fall
when all of the screws are removed.
4. Remove the glass light cover, gasket, and steel
frame..
5. Remove the bulb by firmly grasping and sliding the
bulb straight out until the two prongs have cleared the
ceramic holder.
20
Slot
Removal position
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.
3. Fully open the
door. If the door
edge of slot
will not fully open,
the indentation
is not seated
correctly in the
bottom edge of
the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
Hinge
arm
Hinge
lock
Push hinge locks up to lock
5. Close the oven door.
6. Do not touch the glass of the new replacement bulb
with your fingers. It will cause the bulb to fail when it
lights. Grasp the replacement bulb with a clean towel
or facial tissue with the prongs facing down. Align the
two prongs in the ceramic holder, pressing gently until
the bulb is securely in the ceramic socket.
7. Align the frame, gasket, and glass in a horizontal
position and rotate them into place on the oven wall,
taking care not to pinch the silicone gasket seal.
8. Re-insert the screws that were previously removed.
9. Reconnect power.
Bottom
Hinge arm
Indentation
49-2000695 Rev. 1