System Connection; Overview; Installation - Leviton 41920-HRC Manual Del Usuario

41920-HRC

System Connection

Overview

Projector/Flat Screen Display
Laptop
Computer

Installation

1. If installing in a back-box, it is recommended that the 41920-HRC Autoswitching Wallplate be
installed in a 4-5/8" square box at a minimum. The 4-5/8" square box has sufficient space to
terminate the cables with jacks behind the unit when fully installed
2. Run one twisted pair cable from the Autoswitching Wallplate location to the location where the
HDBaseT receiver will be located (somewhere near the display device). See the installation
instructions for the 70M HDBaseT Extender Receiver (41920-HTR)
3. If using the 41920-CP8 8-button Control Panel, run another twisted pair cable from the
Autoswitching Wallplate location to the location that the 8-button Control Panel will be
mounted.
4. All twisted pair cables should be terminated with jacks. This allows the permanent link
between the two devices to be tested
5. Use the appropriate category rated patch cable to connect the HDBaseT link to the HDBT OUT
connector
6. If using the 41920-CP8 –button Control Panel, use the supplied adapter cable to connect with
the second cable and follow the installation instructions for the receiver and 8-button Control
Panel
HDMI
41910-HTR
AC
Power
Cat 6A
Cat 6A
HDMI
Audio
VGA
HDMI
41920-HRC
7
Category Cable
HDMI Cable
Audio Cable
VGA Cable
Desktop
Computer
DVD Player
DI-010-41920-25C