Twisted Pair Cabling; System Operation; Source/Auto Button; Troubleshooting - Leviton 41920-HRC Manual Del Usuario

41920-HRC

Twisted Pair Cabling

For best performance, twisted pair cable should be installed in accordance with TIA-568-C.0 and
NEC 300 and field certified using ANSI/TIA-568 UL approved testers
NOTE: Leviton recommends Category 6A cabling with alien crosstalk prevention technology for best
performance of HDBaseT link.

System Operation

SOURCE/AUTO Button

Press and hold the SOURCE/AUTO button for approximately 3 seconds. When the button lights up
green the Autoswitching Wallplate is in AUTO mode. This mode automatically selects the last video
source connected to the Autoswitching Wallplate and outputs it to the display. Press and hold again
for approximately 3 seconds, the light will go out, and the device will be in MANUAL mode which will
allow the user to momentarily press the button to toggle between the three sources.

Troubleshooting

INDICATOR
POWER OFF
LINK OFF
HDCP OFF
NOTES
If your problem persists, please call technical support at (800) 824-3005

Warranty

Go to www.leviton.com/warranty
INDICATOR STATUS
SOLID SOLID SOLID
RED RED RED
BLINKS SOLID
OFF
GREEN GREEN
OFF OFF OFF
for more information
SOLID
RED
SOLID
GREEN
SOLID
GREEN
8 DI-010-41920-25C