Cleaning And Maintenance; Wet Accessory - cecotec CONGA ROCKSTAR 500 X-TREME ERGOWET Manual De Instrucciones

ENGLISH
It can be assembled with screws (included with the product), or with an adhesive (included
with the product).
When using the adhesive, make sure to use it on a clear flat surface.
Also make sure that the suction base rests on the floor when hang to avoid the wall bracket
from falling.
Fig. 9
Charging
The device can be charged in 2 different ways. It can be charged directly through the handheld
vacuum cleaner or the battery can be removed and charged separately.
It is important to charge it when the battery is low. While charging, the battery indicator will
turn on red, and it will turn green when battery is fully charged again.
Disconnect it from the power adapter when the battery indicator is lit up in green.
Fig. 10

5. CLEANING AND MAINTENANCE

Do not use abrasive scouring pads, powders or cleaners to clean the product.
Use a soft, dampened and clean cloth to clean the product's outer housing.
Do not let water enter into the vacuum cleaner.
Keep the appliance in a cool, dry place and out of reach from children.
Do not immerse the device in water and do not clean any of its parts in the dishwasher.
Dust tank
To empty the dust tank, first disassemble the handheld vacuum cleaner from the rest of the
unit. Use the tab on the dust tank to open its cover and empty it. If necessary, shake it gently
to remove all the dust.
Fig. 11
To clean it, press the dust tank release button and turn the dust tank anticlockwise to the
unlock position. Remove it. Use water to rinse it. If necessary, clean it with soap to remove all
the dust.
Recommendation: It is suggested to clean the dust tank after each use.
Fig. 12
Filters
It is suggested to clean the filters regularly to ensure maximum efficiency. They can be cleaned
with warm water. Dry them thoroughly before installing them back in the device.
To take filters out:
Open the dust tank following the instructions on the before section.
44
CONGA ROCKSTAR 500 X-TREME ERGOWET
Turn the metallic filter anticlockwise and remove it.
Fig. 13
Unscrew the plastic cyclone and remove it too.
Pull from the tab located on the top of the handheld vacuum cleaner and remove the high-
efficiency filter.
Wash all of them with warm water.
Allow them to dry completely before installing and using them again.
Fig. 14
Jalisco brush
Recommendation: It is important to clean the brush regularly to avoid hair and other foreign
objects from tangling and to prevent blockages.
Press the brush release button on the bottom part of the suction base and remove the brush.
Wash it with warm water. Do not use detergents or soap.
Make sure it is completely dry before installing it back in the device.
Fig. 15

6. WET ACCESSORY

Before use
Take the product out of the box.
Remove all packaging materials. Keep the original box.
Make sure all the components are included and in good conditions, otherwise, contact
immediately the official Technical Support Service of Cecotec.
When you do not use the vacuum cleaner for a long time, please remove the water tank and
empty the remaining water. Do not expose it to direct sunlight or to damp environments.
Mop installation/removal
Removing/installing the water tank
Fig. 16
In order to install/remove the cleaning cloth you must first disassemble the water tank from
the rest of the appliance.
In order to remove the water tank, use your foot to hold it against the ground and pull upwards
until it unclicks from position.
Once the cloth has been installed and the water tank has been filled, to reinstall the water tank,
simply push it back together until it clicks into position.
Note: Do not use cleaning agents. Use clean and room temperature water only. Do not use the
vacuum cleaner to vacuum water.
Installing the mop cloth
ENGLISH
CONGA ROCKSTAR 500 X-TREME ERGOWET
45