Configuring A Dynamic Ip Address - Dynex DX-E201 Guia Del Usuario

Dynex5x7-multi.book Page 11 Thursday, September 8, 2005 11:07 AM
Setting up the network card

Configuring a dynamic IP address

When the drivers are installed, the default setting is to obtain an IP address
dynamically through a DHCP server.
If you need to check or change the settings, do the following:
1 Click Start, Settings, then click Control Panel. The Control Panel window
opens.
2 Double-click Network. The Network window opens.
3 Click TCP/IP, then click Properties. The TCP/IP window opens. If TCP/IP is
not present, see "Installing TCP/IP" on page 8.
11