Dynex DX-E201 Guia Del Usuario página 26

Dynex5x7-multi.book Page 26 Thursday, September 8, 2005 11:07 AM
26
P
INGING YOUR NETWORK CARD
PING is the acronym for Packet Internet Groper (PING), a utility to determine if a
specific IP address is accessible. It works by sending a packet to the specified
address and waiting for a reply. Ping is primarily used to troubleshoot Internet
connections. By sending out a ping, you are verifying that a specific computer is
available. Because all computers on the network must have a unique IP address,
getting a reply means that a computer is on the network and that it can
communicate.
If the computers can communicate, the hardware and cabling are probably okay. If
you cannot ping another computer, there is probably a problem with the
hardware. Check the cabling and adapter installation. If you are unable to
network, even when you receive a reply to your ping, there is probably a software
configuration problem. Verify that all the settings are correct.
To ping the network card:
1 Click Start, then click Run. The Run dialog box opens.
2 Type command in the Open box, then click OK. The command.com screen
opens.
3 Type ping xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP address you
want to ping). In this case, computer B with the IP address=192.168.0.1 is
being pinged from computer A.
4 Press Enter to begin pinging. If the connection is good, you receive four
"Reply from" messages.
5 Type exit at the prompt to return to Windows.
Troubleshooting