Descargar Imprimir esta página

Installation  Instalación - GRAFF G-8231 Instrucciones De Instalación

Ocultar thumbs Ver también para G-8231:

Publicidad

See fig. 2-11
Use a pen to draw points, then drill holes with Ø10mm percussion bit (fig. 3).
1.
2.
Use hammer to put anchor bolts into wall to fix ceiling mounting rack, then screw it tight with wrench (fig. 4).
3.
Take the screw components out and install it to the mounting rack, then tighten the nuts (fig. 5). NOTE: Before installation, to measure
the installation length of mounting rack then to cut threaded rod. The finished threaded rod should less than the length of mounting rack.
(The processing range of threaded rod is 2-3/8"(60mm)-19-11/16"(500mm)) (fig. 6).
4.
Take out the power adapter and power line, connect them as picture 8. Connect the water pipe and power (fig. 9).
5.
Put the threaded rod into shower, then fix the screw nut with hexagon wrench, tighten it then lay down the shower slowly (fig.10).
This product is single function celling shower head with LED light, the LED color can be changed by remote controller (fig. 11).
6.
REMOTE CONTROL INSTRUCTIONS  INSTRUCCIONES DE CONTROL REMOTO
Technical Parameters
working temperature: -20ºC ~ 60ºC
power supply mode:
battery
supply voltage: 1.5V*3
standby power consumption: 0.015mW
standby current: 3uA
working current: 300uA
emission current: 12mA
remote distance: 25m
standby time: 6 months
Changes of M key on the touch remote as below:
Function
1
Static red
2
Static green
3
Static blue
4
Static yellow
5
Static purple
6
Static blue-green
7
Static white
8
Three color sequence
9
Three color gradual changing
10
Seven color sequence
11
Seven color gradual changing
IOG 5013.24
SHOWER HEAD (rainfall and mist functions)
ALCACHOFA DE DUCHA (con funciones de lluvia y evaporación)
ENGLISH
:
AAA
Installation Instructions  Instrucciones de Instalación
LED light
INSTALLATION  INSTALACIÓN
Parámetros técnicos:
Temperatura de funcionamiento: -20ºC ~ 60ºC
Modo de alimentación: Batería AAA
Tensión de alimentación: 1,5V*3
Consumo de energía en standby: 0,015mW
Corriente standby: 3uA
Corriente de funcionamiento: 300uA
Corriente de emisión: 12mA
Distancia remota: 25m
Tiempo en espera: 6 meses
Remark
Speed is unadjustable, brightness is adjustable
Speed is unadjustable, brightness is adjustable
Speed is unadjustable, brightness is adjustable
Speed is unadjustable, brightness is adjustable
Speed is unadjustable, brightness is adjustable
Speed is unadjustable, brightness is adjustable
Speed is unadjustable, brightness is adjustable
Speed is adjustable, brightness is unadjustable
Speed is adjustable, brightness is unadjustable
Speed is adjustable, brightness is unadjustable
Speed is adjustable, brightness is unadjustable
6
11
ENGLISH
~
ESPANOL
ENGLISH
Rev. 2 April 2019

Publicidad

loading