System Operation; Frequently Asked Questions (Faqs) - Broan MD6T Manual De Instalación

SYSTEM OPERATION

Once the Damper and the associated BEST, Broan Elite or Broan
exhaust devices are installed, the installer should confirm that the
Damper opens and closes in conjunction with signals from the
exhaust devices(s) as intended.
A qualified HVAC contractor should also ensure the proper
operation and venting of all combustion equipment in the home.
MAINTENANCE
Regular maintenance is necessary to ensure the proper operation
of the Damper system. Failure to conduct such routine maintenance
can jeopardize the ability of the Damper to introduce fresh air into the
home. Regular maintenance should include the following activities:
• Clean the outside bird screen to ensure it is free from debris and
open to allow fresh air to enter.
• Clean or replace the interior filter(s) which serve to filter fresh air
before it enters the home.
• Maintain a clear opening at the outdoor end cap, which means pre-
venting the buildup of snow, leaves, or vegetation at the end cap.
• During regular HVAC maintenance, have the mechanical contrac-
tor inspect the Damper system for proper operation.
FREQUENTLY ASKED
QUESTIONS (FAQS)
1. What does the Broan Automatic Make-Up Air
Damper do?
The Broan Automatic Make-Up Air Damper (the "Damper") provides a
pathway for fresh air to enter a home from outdoors when a compatible
exhaust device is operating. The Damper opens when a compatible BEST,
Broan Elite or Broan range hood is operating, thereby creating a known,
controlled point for fresh air to enter the home while air is being exhausted
from the building by the range hood.
By operating in this manner, the Damper provides two key benefits for the
home:
• It facilitates air exchange between indoors and outdoors, by helping to
allow fresh air into the home to replace air which is exhausted out of
the home.
• By allowing fresh air into the building when a compatible exhaust device
is on, the Damper helps to avoid negative pressure conditions within
the home which may interfere with the proper operation of combustion
equipment within the home.
Overall, the Damper let's your BEST, Broan Elite or Broan exhaust
devices do their job more effectively and without interfering with the proper
operation of other home systems.
MODELS MD6T • MD8T • MD10T
2. Does the "Damper" provide combustion air for combustion
appliances like a water heater or
a furnace?
No. The Damper helps to replace air which is exhausted by a compatible
range hood. But it does NOT help to replace air which is drawn from the
indoors by a combustion appliance like a natural gas water heater, and it
should not be relied upon to perform this function. One main reason for
this restriction is that the Damper is only open when the range hood that
it's connected to is operating. So there is no assurance that the Damper
would be open when other appliances, like a water heater, are operating.
Other means must be provided to ensure adequate combustion air for
these appliances.
3. How do I know if I need make-up air for my
range hood?
In some cases the local building code may tell you that make-up air is
necessary. For example, some codes specify that range hoods with
exhaust flows of 300 cubic feet per minute (CFM) or higher need a
mechanical system to introduce make-up air.
In other cases, make-up air for a range hood is desirable regardless of
whether code requires it. This is especially true for:
• larger range hoods (those over 300 cfm)
• homes which are well air-sealed - so outside air may not be able to
easily find its way into the home through cracks, to replace air which is
exhausted out
• homes with atmospherically
(i.e. a water heater or natural draft fireplace), which are more
susceptible to improper venting if depressurization occurs in
the home.
In homes with any one of these factors make-up air is advised. And in
homes with more than one of these conditions make-up air for the range
hood is strongly advised.
4. What are the benefits of providing make-up air to replace air
which is exhausted out of the home by a range hood?
Range hoods are designed to pull out pollutants like cooking odors or
moisture at the source, so they don't linger in the home. Because these
fans pull air out of the house, this air needs to be replaced with "new" air
from outdoors. Normally this make-up air enters the home through cracks
and holes in the "shell" of the building. But modern homes are air-sealed
much more thoroughly so there are not as many cracks and openings.
Plus some exhaust fans like range hoods exhaust a lot more air than can
be replaced through normal cracks in the building shell.
By providing an intentionally designed opening for fresh air to replace
air which is exhausted out by the range hood, several important benefits
result:
• The make-up air entering the home comes in at a known point, where
it is also filtered
• Negative pressure conditions, which could arise if air is exhausted from
a home without being replaced by new fresh air, are prevented
• Pollutants are more effectively exhausted from the home while fresh
replacement air is drawn into the home, improving ventilation
Page 4
vented combustion appliances