Intended Use; Height Adjustment; Telescopic Variant; Crank Variant - Stellcase Ology Guía Rápida

3. Intended use

Intended use also includes following all instructions in the user manual.
The Ology desk / Ology Bench is designed exclusively for use as office furniture for commercial use.
Any other use, or use beyond the specified intended use is considered to be improper use. Improper use
of the product may result in dangers to life and limb as well as property damage. For this reason,
improper use is prohibited. In case of improper use, Steelcase assumes no liability for any damage that
may occur and does not guarantee that the components will function properly. Improper use includes:
Use for the lifting of loads
■
Use as a climbing aid
■
Permanent storage surface for objects with a
■
total weight of more than approx. 75 kg

4. Height adjustment

Optimum desk height
Adjustment to the optimum desk height (sitting height) is crucial for the
correct sitting posture at the workstation. The correct desk height setting for
the workstation can be found in the workstation analysis (pursuant to the
German Occupational Safety and Health Act, the German VDU Ordinance, or
accident prevention regulations, for example). See also BGI 650: Screen and
office workstations: Design Guidelines.

4.1 Telescopic variant

 Loosen the adjustment wheel.
 Pull up or slide down the telescopic column by
the desired length (see scale).
desk top while doing so.
 Tighten the adjustment wheel.
 Adjust all columns to the same height.
4.3 Variants Lift 1 and Lift 2
ATTENTION
Before first use make sure that
the desk has been assembled correctly;
■
the controller is connected to the motor by cable;
■
the control panel is connected to the controller;
■
all safety-relevant information has been followed.
■
Prior to placing the desk in service, it is necessary to perform a manual reset.
122957
Outdoor use
■
Use in damp rooms
■

4.2 Crank variant

 Pull the crank out of the parking position.
 Crank the telescopic columns up or down by
Hold the the desired height (see scale). All columns are
moved simultaneously.
 Do not lift the desktop during cranking.
 Push the crank back into the parking position.
EN
Rev. E