Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
®
Alternative installation instructions using screws/anchors from optional hardware package
Corner sensors with mounting screws:
-
Using mounting bracket as a template, mark location of holes on mounting surface.
-
If using anchors: drill 3/16" holes, insert anchors and attach mounting bracket base with screws.
If not using anchors: attach mounting bracket base with screws.
-
Snap mounting bracket top into base.
NOTE: If corner is not square, use only one mounting screw and attach to just one wall.
mounting bracket top
mounting bracket base
If a sensor needs to be relocated:
-
Remove sensor from bracket.
-
Use 3/16" (5mm) flathead screwdriver and
pry on retention tabs inside the mounting
bracket to remove top cover.
-
Remove screws or staples.
-
Gently twist mounting bracket back and
forth until adhesive pulls away from wall.
(Using a metal spatula can make removal
of bracket with adhesive tape easier.)
-
Remove old adhesive tape and replace
with new adhesive tape from optional tape
kit (Style #ST02MKT051020).
-
Re-install per previous instructions.
retention tabs
Page 12 of 41
1083528001 Rev B
Publicidad
Tabla de contenido
