INSTALLATION ON CONCRETE WALL, CONCRETE LINER OR SHELL
The processes of implementation are the same as with tradiational models.
1 - Open the lid and remove the basket.
2 - With the pool pump running, close the opening of the skimfiltre
3 - Wait until the tank is emptied of its water, remove the cartridge block and then the cartridge.
4 - Replace the blue plate of the opening.
Cleaning takes place on average once every 3 weeks depending on the rate of use of the pool and the pool size.
Clean the cartridge with a water jet and soft brush. In case of heavy soiling of the cartridge or scaling, soak the
cartridge in a solution of detergent or descaling agent. It is advisable to use a set of two cartridges to avoid stopping
the filtration of the pool during the cleaning operation.
1 - Open the lid and remove the basket.
2 - With the pump stopped, slowly immerse the cartridge until you feel the bottom, then close the handle.
3 - Place the block on top of the cartridge.
4 - Replace the basket and start the pump.
5 - Replace the cover
WELBAG pre-filter for the basket: This disposable 'sock' installs in seconds on the basket. It reduces maintenance
and reduces filter clogging by collecting all the debris in the water (leaves, needles, insects ...).
Ultra-concentrated FLOVIL clarifying agent (chips): Increases the fine action of the filter by coagulating the
fine particles suspended in the water which are then stopped by the filter. Its action reduces filtration time, the
consumption of chlorinated products and anti-algae products by up to 50%.
REMOVING THE CARTRIDGE FOR CLEANING
CLEANING THE FILTER CARTRIDGE
REPLACE THE CARTRIDGE IN THE SKIMFILTRE
MAINTENANCE OF THE CARTRIDGE
set up the foam
block before pouring
concrete
Page : 12