Vasner Appino BEATZZ Manual De Instrucciones página 24

VASNER
Wall installation distances:
Ceiling
min. 0.5 m
Window
Floor
Commissioning
After switching the heater on using the On/off switch, you can control the
heater in three ways: using the supplied remote control, via the free app or by
simply clicking pressing the reset button on the side of the casing.
Operation using the remote control:
1. Insert two AAA 1.5 V batteries in the remote control. When using the
infrared remote control, always point it directly at the heater as it does not
work if there are any obstacles between the remote control and the heater.
2. Plug the heater into the socket
3. Then press the On/off switch (3.) on the side of the heater. The switch must
be in the "I" position. The blue LED (7.) on the front of the heater lights up.
4. Switching on: Now press the "On" button on the remote control to switch
on the heater. The heater first switches on at 33%, "Gentle start".
After 4 seconds, it returns to the heating setting that was last selected.
When the heater is used for the first time, it switches to the maximum
setting after 4 seconds. The LED that was previously blue is now red (7.).
5. Dimming: You can use the arrow keys to dim the radiator, reducing or
increasing intensity. Alternatively, the device can also be dimmed directly
by pressing the reset button several times manually.
24
min. 1.8 m
Ceiling installation distances:
Window
Floor
GB
Bracket
Ceiling
min. 1.8 m