General Power Tool Safety Warnings; Circular Saw Safety Warnings - Makita 5008MG Manual De Instrucciones

ENGLISH (Original instructions)
1. Depth guide
2. Lever
3. Positive stopper
4. Arrow on positive stopper
5. Base
6. Switch trigger
7. Lamp
8. Hex wrench
9. Protrusion
SPECIFICATIONS
Blade diameter
Max. Cutting depth
No load speed (min
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece. With
appropriate Makita genuine saw blades, other materials
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.37 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
Explanation of general view
10. Shaft lock
11. Saw blade
12. Hex bolt
13. Outer flange
14. Inner flange
15. Ring
16. Vacuum cleaner
17. Rear handle
18. Front grip
Model
at 90°
at 45°
at 50°
-1
)
Net weight
Safety class
power tool. Failure to follow all instructions listed below
ENE078-2
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
ENF002-2
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
CIRCULAR SAW SAFETY
WARNINGS
ENF100-1
Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on
auxiliary handle, or motor housing. If both hands
are holding the saw, they cannot be cut by the blade.
2. Do not reach underneath the workpiece. The guard
cannot protect you from the blade below the
workpiece.
3. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
4. Never hold the workpiece in your hands or across
your leg while cutting. Secure the workpiece to a
GEA010-2
stable platform. It is important to support the work
properly to minimise body exposure, blade binding, or
loss of control. (Fig. 1)
19. Rip fence (Guide rule)
20. Hole for lanyard (tether strap)
21. Adjusting screw
22. Triangular rule
23. Limit mark
24. Brush holder cap
25. Screwdriver
5008MG/5008MGA
210 mm
75.5 mm
57 mm
51.5 mm
5,200
332 mm
4.8 kg
/II
GEB133-2
5