Goldstar WG1805R Manual Del Propietário página 11

Installation
114Bubble
I
Level
INSIDE
FOAM ...............
COOLED
OUTSIDE FENCE
AWNING;
HEAT
RADIATION
About 1/2"
Over 20"
1. To avoid vibration and noise, make sure the unit is installed securely and firmly.
2. Install the unit where the sunlight does not shine directly on the unit.
If the unit receives direct sunlight, build an awning to shade the cabinet
3, There should be no obstacle, like a fence, within 20" which might restrict heat radiation from the condenser
4. To prevent reducing performance, install the unit so that louvers of the cabinet are not blocked.
5. Install the unit a little obliquely outward not to avoid leaking the condensed water into the room (about 1/2"
or 1/4 bubble with level).
6, Install the unit with its bosom portion 30-60" above the floor level,
7. Stuff the foam between the top of the unit and the wall to prevent air and insects from geeing into the room,
8. The power cord must be connected to an independent circuit. The green wire must be grounded.
9. Connect the drain tube to the base pan hole in the rear side if you need to drain (consult a dealer.)
Pl_tic hose or equivalent may be connected to the drain tube,
The grille is designed to clean the filter both upward and down_rd.
®
(a) (b)
(c)
A. Before attaching the front grille to the cabinet, ff you want to puff out the filter upward;
1. Open the inlet grille slightly (a).
2_Turn inside out the front gr[He (a).
3, Disassemble the inlet griile from the front grille with separating the hinged part by inserting a straight type
screw-driver tip (b),
4. Then, rotate the inlet grille 180 degrees and insert the hooks into bottom holes of the front grille.
5. Insert the filter and attach the front grille to the _binet.
B. ff you want to pull out the filter downward;
The grille is already designed that way.
Owner's Manual 11