Goldstar WG1805R Manual Del Propietário página 14

tnstallation
I Open the window. Mark a line on the center of
the window stool between the side window stop
molding&
Loosely attach the sill bracket to the support
bracket using the carriage bolt and the look nut.
Sill
Bracket
Carriag
BoJt
(M-Screw)
nut
Fig, 5
2. Attach the sill bracket to the window sill using
the screws (Type B),
Carefully place the cabinet on the window stool
and align the center mark on the bottom front
with the center line marked window stool.
3, Using the M-screw and the lock nut, attach the
support bracket to the cabinet track hole, Use
the first track hole after the sill bracket on the
outer edge of the window sill. Tighten the
carriage bolt and the lock nut. Be,sure the
cabinet slan_ outward,
A CAUTION
Do not drill a hole in the bottom pan. The unit is
designed to operate with approximately 1/2" of
water in bottom pan,
4. Pull the bottom window sash down behind the
Top retainer bar until they meet.
1. Do not pull the window sash down so tightly
that the movement of Frame curtain is
restricted Attach the cabinet to the window
stool by driving the _rews (Type B) through
the cabinet into window stool.
2. The cabinet should be installed with a very
slight tilt downward toward the outside.
quietedge
Of w_naow
sill
B)
Sill bracket
Fig, 6
retainer
bar
Wind_ st_l
Frontangle Fig. 7
Window sash retainer bar
Frame curtain
Foam-PE
Fig. 8
Front A_le
Screw(TypeB) Fig, 9
14 Room Air Conditioner