Using The Measuring Handset - Yealink DECT IP Multi-Cell Deployment ToolKit Guia De Inicio Rapido

Using the Measuring Handset

The idle screen
The LCD screen shows the following information in the idle screen:
The talking screen
If the handset is in the talking screen, it shows the measurement data at the top edge.
Note:
If one handset is used, you can enter #*9 on the handset to perform an analog call.
Indicates the signal strength between the base station and
registered handset.
Weak to strong:
No reception:
Indicates the current battery status.
Low to full:
Need charging:
Values for determining the connection quality:
RSSI: Base station signal reception strength with the best
Fr. quality: Frame quality. Percentage rate of the packages
Base Station: RPN (Radio Fixed Part Number) of the base station.
Frequency: Carrier frequency of the signal received.
Slot pair: Time slot for the reception channel on which the
Fr. quality
RSSI
(red)
reception in dBm.
Recommended value: -28 to -70 dBm.
Note: The RSSI value is displayed in dBm as standard, you
can change it into a percentage value.
received without error in the last measuring interval.
Recommended value: 100%.
Identifier for the base station to which the handset
is connected.
Value range: 0-30.
measurement was performed.
Duplex Slot pair used (0-11).
Frequency
Slot pair
Base Station
E
N
G
L
I
S
H
5