Whale SH2202 Instrucciones De Instalación Y Usuario página 19

For Electric Operation: The Space Heater is equipped with 3 power settings 500W / 1000W / 2000W. Turn the
selector knob to low power setting for 500W.
Turn the selector knob to medium power setting for 1000W.
Turn the selector knob to high power setting for 2000W.
When operating on low and medium electric power settings, the blown air fan runs at a reduced speed to minimise
noise and current draw.
Note: The electric elements will still operate if the appliance is in gas ignition lock-out.
The appliance cannot be operated with both gas and electric.
Switching Appliance Off: Turn the selector knob to the 'Off' position ( ).
Note: The fan will continue to run for 3 minutes to allow the Space Heater to cool down.
Adjusting The Temperature: Turn the temperature control knob clockwise to increase and anti-clockwise to reduce
the room temperature. The Space Heater will automatically turn itself on and off to maintain the desired ambient
temperature.
Note: The Control Panel incorporates a low temperature / frost protection setting. This can be activated by turning
the temperature control knob fully anti-clockwise.
Option 2 - Whale Duo Control Panel
Gas Light - Water Heater
Water Heater Function
Diagnostic LED - Water Heater
Gas Light - Space Heater
Space Heater Function
Diagnostic LED - Space Heater
For Gas Operation - Space Heater: Press the Space Heater Function key until the 'gas' icon is illuminated. There
will be a pre-purge pause of approx. 30 seconds to allow any un-burnt gas to leave the flue. A green LED will light
upon successful flame ignition. If there is air in the gas supply line it may take a few attempts for the gas to ignite.
See Section 9 for gas lockout re-setting. If the ignition is not satisfactory the Space Heater Diagnostic LED on the
Control Panel will light. If the Diagnostic LED is lit please refer to the Trouble Shooting Guide (see Section 9).
For Electric Operation - Space Heater: The Space Heater is equipped with 3 power settings 500W/1000W /2000W.
For 500W Press the Space Heater Function key until the 'low power setting' icon is illuminated.
For 1000W Press the Space Heater Function key until the 'medium power setting' icon is illuminated.
For 2000W Press the Space Heater Function key until the 'high power setting' icon is illuminated.
When operating on low and medium electric power settings, the blown air fan runs at a reduced speed to minimise
noise and current draw.
Note: The electric elements will still operate if the appliance is in gas ignition lock-out.
The appliance cannot be operated with both gas and electric.
Switching Appliance Off: Press the Space Heater Function key until 'Off' is illuminated.
Note: The fan will continue to run for 3 minutes to allow the Space Heater to cool down.
WATER HEATING
HEATING
Control Panel by
Fig. 35 Whale Duo Control Panel
19
Temperature Control