Instructions For Installation - Whale SH2202 Instrucciones De Instalación Y Usuario

6.

INSTRUCTIONS FOR INSTALLATION

The Whale® Space Heater can be installed either inside the vehicle (Part Number: SH2202) as in Fig. 2 or under the
floor (Part Number: SH2212B) as in Fig. 3, depending on which model has been purchased.
Exterior Wall
Cold Air Inlet Duct
Hot Air Outlet Duct
Vehicle Floor
Vehicle Floor
To the Fitter:
Installation and servicing of this appliance must only be carried out by competent persons registered with the Gas
Safe Register (GB) or the relevant national organisation, in accordance with the relevant regulatory and safety
requirements.
Before installation, you must ensure the appliance has been supplied in good condition and if damaged do not
install.
A competent person must install the appliance in accordance with the appliance installation instructions. This
appliance is for use with LPG (see appliance data plate) and mains electricity (230V a.c.). Check that the product is
suitable for the intended application. In particular the installer must check the compatibility of the data plate
information with the LPG supply requirements of the vehicle. Follow these installation instructions and ensure all
relevant personnel read the points listed below. Ensure that these operating instructions are passed on to the end
user.
Please note: The appliance must be installed in accordance with any relevant regulations in the country where the
appliance is installed. For this appliance in Europe, the standard is BS EN 1949:2011 "Specification for the
Installation of LPG Systems For Habitation Purposes In Leisure Accommodation Vehicles And In Other Road
Vehicles".
Ventilation must comply with relevant national and/or local requirements.
Interior Wall
Exhaust Flue
Fig. 2 Internal Installation
Hot Air Outlet
Cold Air Inlet
Combustion Air Inlet
Exhaust Flue
Fig. 3 Underfloor Installation
6
Space Heater
Gas Pipe
Combustion Air Inlet
Gas Pipe
Space Heater