Change User Code; Change Admin Code - Zodiac Security ZS-10A Manual De Instrucciones

Change user code

The user code may be required to interact with the control panel (arm or disarm
the system, or switch to Home Mode). We recommend you to change the user
code before using the keypad for the first time.
1. Enter Setup Mode.
2. Type [38 + new user code
3. You hear one beep: the setup is successful.
Note
The user code must consist of 4 digits.
Default user code is: 1234.

Change admin code

The admin code may be required to change the settings and interact with the
control panel (arm or disarm the system or switch to Home Mode) We
recommend you to change the admin code before using the keypad for the first
time.
1. Enter Setup Mode.
2. Type [39 + new admin code
3. You hear one beep: the setup is successful.
Nota
The user code must consist of 6 digits.
Default user code is: 123456.
Reset
After having reset the keypad, the user code, the admin code, and other settings
will be restored to default settings. The RFID tags that have been registered will
not be deleted from the keypad.
1. Enter Setup Mode.
2. Type [987654321#].
3. You hear one beep: the setup is successful.
+ #].
+ #].