Zodiac Security ZS-10A Manual De Instrucciones página 27

FAQ
Problem
No response from
the keypad
The keypad cannot
be registered to the
control panel
No response from
the control panel
when operating on
the keypad
Cannot disarm the
system by RFID tag
The keypad cannot
be set up
The keypad cannot
arm, disarm or switch
to Home Mode
Cause
Low battery
The batteries' positive
and negative terminals
are reversed
The keypad is locked
No response from the
alarm panel
The keypad is not
registered in the control
panel
The keypad is installed
too far from the control
panel
The RFID tags have not
been registered in the
keypad
The RFID reader is
disabled
The keypad is locked
The keypad is not
unlocked
The keypad does not
switch to Setup mode
Your user code or admin
code has not been typed
before each operation
Solution
Change the battery
Remove and insert the
batteries again according to
the instructions in this manual
Press Arm or Home Mode on
the keypad to unlock it
Make sure the alarm panel
is on.
Make sure the alarm panel
is in Connection Mode.
Registered the keypad in the
control panel by following the
instructions in this manual
Install the keypad and the
control panel closer to each
other.
It is recommended to buy a
repeater to extend the
transmission distance.
Register the RFID tag in the
control panel according to the
instruction in this manual
Enter Setup mode and activate
the function "Enable / Disable
deactivation by RFID tag"
Press Arm or Home Mode,
then [*] before disarming
Refer to instruction in this
manual
Refer to instruction in this
manual
Type your user code or admin
code before the operation