Napa 791-7200 C Manual De Instrucciones

BEFORE USING THIS DEVICE, READ THIS
MANUAL COMPLETELY AND THOROUGHLY,
UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND
MAINTENANCE REQUIREMENTS.
It is the responsibility of the device owner to make sure all personnel
read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient
location for all to see and read. If the manual or product labels are lost
or not legible, contact NAPA for replacements. If the operator is not
fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by
the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
SPECIFICATIONS
Required Air Pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 PSI
Low Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .35"
Raised Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73.5"
Saddle Forward Tilt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37º
Saddle Backward Tilt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26º
Saddle Lateral Tilt . . . . . . . . . . . . . . . . . . . . . . . . . .12º left and right
Base . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30-1/4" square
Shipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 167 Lbs.
791-7200 C
1/2 TON AIR & HYDRAULIC
TRANSMISSION JACK
• Read, study, understand and follow all instructions before
operating this device. • Inspect the jack before each use.
Do not use jack if damaged, altered, modified, in poor
condition, leaking hydraulic fluid, or unstable due to loose
or missing components. Make corrections before using.
• Consult the vehicle manufacturer for the transmission's
center of balance. • Secure the transmission to the jack's
saddle with the anchorage restraint system provided
before raising or lowering the transmission. • Center load
on saddle. Be sure setup is stable before working on
vehicle. • Support the engine with a stand before unbolting
the transmission from the engine. • Wear eye protection
that meets ANSI Z87.1 and OSHA standards. • Do not use
jack beyond its rated capacity. • Use only on a hard level
surface. • Adequately support the vehicle before starting
repairs. • Use of this product is limited to the removal,
installation and transportation in the lowered position, of
transmissions, transfer cases and transaxles. • Do not
use any adapters unless approved or supplied by NAPA. •
Always lower the jack slowly and carefully. • This product
contains one or more chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or
fatal personal injury and/or property damage.
1
Model # 791-7200 C
WARNING
rev. 01/10/12