ANSMANN POWERLINE VARIO X Manual De Instrucciones página 19

some distance to the two contact
pins [1b] of the charger, so that the
battery contacts are visible [2].
2. Move the contact pins of the charger
by using the lateral sliders [1c] to the
position of the positive and negative
battery contacts. If the contacts on
the battery are not identified, please
take the two outer contacts.
3. Fix the battery again, so that the
battery contacts press to the con-
tact pins of the charger [3]. You do
not need to pay attention to the
polarity. When the battery is proper-
ly connected to the charging cont-
acts, the charger detects the polarity
and voltage of the battery and starts
charging automatically. The current
charging status is indicated on the
LCD display [1d].
4. After the battery is fully charged, re-
move it from the charger.
Deutsch |
English
| Français | Italiano | Español
Português | Nederlands