Safety Information; Preparation - Star HSP10P1 Manual De Instrucciones

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product. If you have any questions regarding the product, please call customer service at
1-800-742-5044, 7:30 a.m.-5:00 p.m., EST, Monday-Friday.
1. WARNING: Follow all local electrical and safety codes, as well as the National Electrical Code (NEC)
and the Occupational Safety and Health Act (OSHA).
2. WARNING: Replace damaged or worn wiring cord immediately.
3. WARNING: Do not kink power cable and never allow the cable to come in contact with oil, grease, hot
surfaces, or chemicals.
4. CAUTION: Protect the power cable from coming in contact with sharp objects.
5. CAUTION: Be careful when touching the exterior of an operating motor - It may be hot enough to be
painful or cause injury.
6. CAUTION: Make certain that the power source conforms to the requirements of your equipment.
7. DANGER: Always disconnect power source before performing any work on or near the motor or its
connected load. If the power disconnect point is out-of-sight, lock it in the open position and tag it to prevent
unexpected application of power. Failure to do so could result in fatal electrical shock.
8. DANGER: Do not handle the pump with wet hands or when standing in water as fatal electrical shock
could occur. Disconnect main power before handling unit for ANY REASON!
9. WARNING: Unit must be securely and adequately electrically grounded. This can be accomplished by
wiring the unit to a ground metal-clad raceway system or by using a separate ground wire connected to the
bare metal of the motor frame or other suitable means.
10. DANGER: RISK OF ELECTRIC SHOCK. These pumps have not been investigated for use in
swimming pool areas.
11. WARNING: This product contains chemicals known to the State of California to cause cancer and birth
defects or other reproductive harm.
12. NOTE: Pumps with the "UL" Mark and pumps with the "US" mark are tested to UL Standard UL778.CSA
certified pumps are certified to CSA Standard C22.2 No. 108. (CUS)

PREPARATION

Before beginning installation of product, make sure all parts are present. Compare parts with
package contents drawing. If any part is missing or damaged, do not attempt to assemble the
product. Contact customer service for replacement parts.
Estimated Installation Time: 2 hours.
3